Table of Contents
Advertisement
Status
Normal
Leased:MR*
Operation
p
Idle:MR*
OnLine:MR*
EC**
Ring Indicate
Test:MR*
Alarm***
Make Busy
Power On Fail
SelfHealth Fail
Call Setup
Off Hook
Dialing
Remote Ring
Training****
EC Negotiating
Dial Backup or
p
Standby: MR*
L
Leased Backup
d B
k
DialBckUp:MR*
Backup:MR*
EC**
Standby:MR*
EC**
* MR. Modem Rate indicates the data rate the modem is using. One of the following values appears:
300, 1200, 2400, 4800, 7200, 9600, 12.0 (12,000), 14.4 (14,400), 16.8 (16,800), or 19.2 (19,200) bps.
** EC. Error Control indicates the modem is online and using V.42 or MNP error control. One of the
following values appears after the modem rates listed above: MNP2, MNP3, MNP4, MNP5, V42, V42b,
or NoEC. (NoEC indicates the modem is connected in Buffer mode rather than error control. If an EC
value does not appear, then the modem is in Direct mode.)
*** The Alarm Status Messages only appear when the Normal Operation Status Messages appear; the
LCD alternates between the two message sets.
**** The Training message may also appear in normal Trellis Multipoint (TMp) operation.
3910-A2-GN32-40
Top-Level Menu Status
Message
The modem is operating on leased lines and transmitting at the
displayed data rate.
The modem is configured for dial network operation and is on-hook.
The modem is online, in Data mode, and operating at the displayed
data rate. EC (error control) appears if error control is operational.
The local modem is receiving an incoming ring.
The modem is in test mode operating at the displayed data rate.
The modem is in a Make Busy condition.
The modem has failed its Power-On Self-test.
A failure has occurred in the modem's hardware components.
The modem is off-hook and waiting to dial a telephone number.
The originating modem is dialing a telephone number.
The remote modem is ringing.
The modem is training or retraining.
The local and remote modems are negotiating the highest possible
level of error control compatible between both modems. Once a
level is selected, this LCD message disappears.
The modem is operating in Dial Standby mode.
The modem is operating in Dial Backup mode at the displayed data
rate and is configured for Direct mode.
The modem is operating in Dial Backup mode and is configured for
error control and data compression on leased lines.
The modem is operating in Dial Standby mode and is configured for
error control and data compression on leased lines.
September 1998
Table 3-3
(1 of 3)
Indicates
DCP Operation
3-9
Advertisement
Table of Contents
