Table of Contents
Advertisement
COMSPHERE 3900 Series Modems
Set Orig Sec
Set Originate Security controls whether or not the modem can originate a call using AT commands
when the dial access security feature is installed. This method of outbound security only applies to
modems originating a call.
To access Set Orig Sec from Set Access Ctrl, make the following selections:
Press the
Select Set_Orig_Sec.
Table 12-3 describes the settings of the Set Originate Security group option.
Set Orig Sec
No_OrigSec EnaOrigSec
Set Originate Security. Controls the security protection for origination of calls when AT commands are used.
NOTE: The originate password must be included in all AT dial command strings if this option is enabled. If
not included, or incorrectly entered, the message ERROR is returned to the DTE.
H No Originate Security
Disables originate security so that a modem can originate a call using AT commands.
H Enable Originate Security
When using AT commands, the modem will only place a call if a valid password is entered along
with an AT dial command. If the password is not entered, then ERROR is returned to the DTE, and
the dial command is canceled.
12-10
Set Access Ctrl
Set_Orig_Sec
F3
F1
F2
key until Set_Orig_Sec appears.
Table 12-3
Set Originate Security Group Options
September 1998
3910-A2-GN32-40
Advertisement
Table of Contents
