Table of Contents
Advertisement
COMSPHERE 3900 Series Modems
Manual Dialing When the Remote Modem is Configured for
Auto-Answer
If you are originating a call using a telephone and the remote modem is configured for
Auto-Answer, perform the following procedure.
Press the
Lift the attached handset and dial the telephone number of the remote modem. When the remote
modem answers, it transmits an answer tone.
When you hear this tone, immediately select Tlk/Data and hang up the handset. This starts the
handshaking sequence between your modem and the remote modem.
If this is successful, the modems are in Data mode and OnLine appears on the LCD.
11-2
On the remote modem, the Line Current Disconnect configuration
option (refer to Line Dialer in Chapter 5, DCP Configuration) must
be set to Disable.
This configuration option does not appear on Models 3910-A1-401
and 3911-B1-001.
Idle:19.2
Tlk/Data
F3
F1
F2
key until Tlk/Data appears.
Idle:19.2
Tlk/Data
F1
F2
F3
Online:19.2
Call_Setup
F1
F2
F3
September 1998
NOTE
>
3910-A2-GN32-40
Advertisement
Table of Contents
