Sony RCP-D50 Operating Instructions Manual page 25

Menu 2ndary menu Submenu
RCP Config VR Setting
(cont.)
(cont.)
Information
Cable Comp
SW Setting
CAM No.
Date/Time
Set
Comm Link
Comm Type
a) Be sure to power off the camera system and then power it on again after changing the "Protocol Type" setting.
Control item
M. Black VR
Cable Length
• SW Assign/Sel
CAM ID->No.
• No.
Date • Year
• Month
• Day
Set
Cancel
Time • Hour
• Minute
• Second
Set
Cancel
Gain
Shutter
R/B White
R/B Black
R/G/B Flare
Protocol Type
Function
(Only available for RCP-D50) To select the response rate of the
MASTER BLACK knob (relative-value adjustment rates: 1/1, 1/2,
and 1/4, where 1/1 is the quickest response position)
To display the software version of the unit
To set the length of the remote cable (5 m/25 m/50 m)
To allocate a function to the ASSIGN button
No Assign: No assignment
Black/Flare: Switching the function of the BLACK/FLARE knobs
Black Auto: ON/OFF of the auto black
ATW: ON/OFF of the auto tracing white balance
TLCS: ON/OFF of the total level control function
DynaLatitude: ON/OFF of the DynaLatitude function
To switch the display of the camera number/tally indication of the
unit between camera ID and camera number
To select the camera number to be displayed on the RCP
Date adjustment of the clock built into the unit
Time adjustment of the clock built into the unit
To turn ON/OFF command link operation (activation of several
cameras at the same time) of the gain
To turn ON/OFF command link operation of shutter settings
To turn ON/OFF command link operation of the white R/B
adjustment
To turn ON/OFF command link operation of the black R/B
adjustment
To turn ON/OFF command link operation of the flare R/G/B
adjustment
a)
To set the connection mode
P Type 2: When connected to DXC-D35, DXC-D50, CCU-TX7,
CCU-D50, DSR-300/370/390/500/570
P Type 7: When connected to CCU-TX50
(Not operative)
(Not operative)
25