Sony RCP-D50 Operating Instructions Manual page 17

Adjustment display (Paint menu)
When you select an item on the initial display of the
Paint menu, the lower half of the panel becomes the
adjustment display for the selected item.
Example: when you select "White" from the PAINT 1 initial display with the DXC-D50 series
connected
When you press this, the upper
half of the panel becomes the
monitor output setting display
( see page 19 ).
The adjustment parameters
for the selected item and their
adjustment values are
displayed.
You may adjust these items
using the corresponding
control knobs.
If you press a value area after
pressing [Clear], that
adjustment value is initialized
to standard.
Submenu
If the selected item has many parameters, a submenu is
displayed.
Example: when you select "Skin Detail" from the PAINT 2 initial display (Advance mode)
with the DXC-D50 series connected
Submenu
Clear
White Black Flare Gamma
Monitor White
Select
Preset Memory Memory
A B
R B
0 0
Clear
Detail Skin
Detail Gamma
WF/PIX
Detail 1
Select
1 2
Level H/V Ratio Frequency
0 0 0
Press to switch the parameters.
WF/PIX Detail 2
Select
1 2
Crispening Level Dep
0 0
The name of the item selected on
the initial display is displayed.
If you press this area after pressing
1 / 5
[Clear], all the adjustment values for
the selected item are initialized to
/Knee
standard.
ATW
When there are any ON/OFF
functions related to the adjustment,
the names of the functions are
displayed on this line.
2 / 5
Black
17