Adobe 25520388 - Premiere Pro - PC Using Manual page 418

USING ADOBE PREMIERE PRO
Effects and transitions
Prevents formants in the audio clip from being affected. For example, use this control when
Formant Preserve
increasing the pitch of a high voice to prevent it from sounding cartoon-like.
Reverb effect
The Reverb effect adds ambience and warmth to an audio clip by simulating the sound of the audio playing in a room.
Use the graphical controls in the Custom Setup view, or adjust values in the Individual Parameters view. This effect is
available for 5.1, stereo, or mono clips.
Specifies the time between the signal and the reverberation. This setting correlates to the distance a sound
Pre Delay
travels to the reflecting walls and back to the listener in a live setting.
Specifies the percentage in which the sound is absorbed.
Absorption
Specifies the size of the room as a percentage.
Size
Specifies the density of the reverb "tail." The Size value determines the range in which you can set Density.
Density
Specifies the amount of dampening for low frequencies (in decibels). Dampening lower frequencies prevents
Lo Damp
the reverb from rumbling or sounding muddy.
Specifies the amount of dampening of high frequencies (in decibels). Low settings make the reverb sound
Hi Damp
softer.
Controls the amount of reverb.
Mix
More Help topics
"Make reverb ring out" on page 293
Spectral Noise Reduction effect
The Spectral Noise Reduction algorithm uses three notch filter banks to remove tonal disturbances from audio signals.
It can help eliminate noises from original footage, such as buzz and whistling tones.
Determines the center frequency of each of the notch filters.
Freq (1-3)
Sets the input gain level at which the color red appears in the meter for a given track.
Reduction (1-3)
Activates the corresponding filter bank.
Filter (1-3)
Determines the gain reduction of each notch filter, thus controlling the amount of noise removed from the
MaxLevel
signal.
Activates the adjustment of the filter frequency by the cursor.
CursorMode
Swap Channels effect
The Swap Channels effect switches the placement of the left and right channel information. Apply to stereo clips only.
Treble effect
The Treble effects lets you increase or decrease higher frequencies (4000 Hz and above). The Boost control specifies
the amount, measured in decibels, to increase or decrease. This effect is available for 5.1, stereo, or mono clips.
Last updated 1/16/2012
413