Adobe 25520388 - Premiere Pro - PC Using Manual page 417

USING ADOBE PREMIERE PRO
Effects and transitions
Notch effect
The Notch effect removes frequencies that are near the specified center. This effects is available for 5.1, stereo, or mono
clips.
Specifies the frequency to be removed. If you are removing power-line hum, type a value that matches the
Center
power-line frequency used by the electrical system where the clip was recorded. For example, in North America and
Japan type 60 Hz, and in most other countries type 50 Hz.
Specifies the range of frequencies to be affected. A low setting creates a narrow band; a high setting creates a wide band.
Q
Parametric EQ effect
The Parametric Equalization effect increases or decreases frequencies near the specified Center frequency. This effect
is available for 5.1, stereo, or mono clips.
Specifies the frequency at the center of the specified range.
Center
Specifies the range of frequencies to be affected. A low setting creates a narrow band; a high setting creates a wide
Q
band. The amount by which frequencies are adjusted is set in decibels by the Boost property. The Boost control
specifies how much to adjust the specified Width in decibels.
Specifies the amount by which to increase or decrease the range of frequencies (between –24 and +24 dB).
Boost
Sweetening audio with Parametric EQ in Adobe Premiere Pro and Audition CS5.5,
Devis.
Phaser effect
The Phaser effect takes a part of the incoming signal, shifts the phase by a varying degree and mixes it back to the
original signal. The result is a partial cancellation of the frequency spectrum, giving the phaser its distinctive sound,
well known as the signature of Motown funky guitars.
LFO (Low Frequency Oscillator) Type
oscillator used to modulate the phase shift.
Determines the speed of the low frequency oscillator. Ranges from 0 to 10.
Rate
Determines the gain level of the modulation waveform, and thus controls the depth of the effect. Ranges from
Depth
0 to 100%.
To achieve a variety of possible effects, the phase-shifted signal will be delayed against the original signal. The
Delay
Delay property sets the time for the delay. Ranges from 0.1 to 4.0 ms.
Determines the amount of phase-shifted signal that will be mixed to the input signal. Using negative values
Feedback
will invert the phase again by 180 degrees. Ranges from -50 to 50.
Determines the ratio of Dry and Effects signal. A setting of 100% corresponds to a ratio of 1/1 while a setting of 0
Mix
will defeat the effect signal. Ranges from 0 to 100%.
PitchShifter effect
The PitchShifter effect adjusts the pitch of the incoming signal. Use this effect to deepen high voices or vice versa. You
can adjust each property using graphical controls in the Custom Setup view, or by changing values in the Individual
Parameters view. This effect is available for 5.1, stereo, or mono clips.
Specifies the change in pitch in semitone steps. The adjustable range is between –12 and +12 semitones.
Pitch
Determines the fine tuning between the semitone grid of the Pitch property.
Fine Tune
Selecting Sine, Rect, or Tri determines the waveform of the low-frequency
Last updated 1/16/2012
in this video tutorial by Andrew
412