Adobe 25520388 - Premiere Pro - PC Using Manual page 355

USING ADOBE PREMIERE PRO
Effects and transitions
Blend effect
The Blend effect blends two clips using one of five modes. After you blend clips using this effect, disable the clip you
selected from the Blend With Layer menu. Select the clip and choose Clip > Enable.
The clip to blend with (the secondary or control layer).
Blend With Layer
Blend mode:
Mode
• Color Only colorizes each pixel in the original image based on the color of each corresponding pixel in the
secondary image.
• Tint Only is similar to Color Only but tints pixels in the original image only if they are already colored.
• Darken Only darkens each pixel in the original image that is lighter than the corresponding pixel in the secondary
image.
• Lighten Only lightens each pixel in the original image that is darker than the corresponding pixel in the secondary
image.
• Crossfade fades out the original image while the secondary image fades in.
The effect's transparency. The result of the effect is blended with the original image, with the effect
Blend With Original
result composited on top. The higher you set this value, the less the effect affects the clip. For example, if you set this
value to 100%, the effect has no visible result on the clip. If you set this value to 0%, the original image does not show
through.
Specifies how to position the control layer.
If Layer Sizes Differ
Calculations effect
The Calculations effect combines the channels of one clip with the channels of another clip.
Original images (left and center), and with effect applied (right)
The channel to extract and use as input to the blending operation. RGBA displays all channels
Input Channel
normally. Gray converts all color channel values for a pixel to the luminance value of the original pixel. Red, Green, or
Blue converts all color channel values for a pixel to the value of the selected color channel for the original pixel. Alpha
converts all channels to the value of the alpha channel for the original pixel.
For instructions on using the Calculations effect and the Ramp effect, see
Gradient In Premiere Pro CS
Inverts the clip before the effect extracts the specified channel information.
Invert Input
The video track with which Calculations blends the original clip.
Second Layer
The channel to be blended with the input channels.
Second Layer Channel
The opacity of the second video track. Set to 0% for the second video track to have no influence
Second Layer Opacity
on the output.
Inverts the second video track before the effect extracts the specified channel information.
Invert Second Layer
by Jeff Schell.
Last updated 1/16/2012
Coloring A Washed-out Sky With A
350