Advertisement
5 Should service, adjustment or trouble-shooting information be needed which
is not covered in this Use and Care Guide, refer to the appropriate
Installation Manual for your model. If you do not have this material, it may
be obtained from your independently operated Culligan dealer.
To clean out the salt storage tank
A periodic clean-out of the Salt Storage Tank is necessary to keep your
Culligan Water Conditioner at peak operating efficiency. Do it at least every 2
years when the salt supply is low. Follow these step-by-step procedures:
Tools needed:
Scoop
Clean, bucket-size container
Phillips-head screwdriver
Garden hose
Household scrub brush or sponge
1 Remove the salt storage tank cover and the cap from the brine valve
chamber.
2 Lift the brine valve out of the brine valve chamber and set aside in an
upright position.
3 If you'd like to save any clean, dry salt remaining in the tank, remove it and
place it in a clean container.
4 Using the scoop, dig out and discard as much remaining salt, water and
debris as possible.
5 Remove the brine valve chamber by removing the screws on either side of
the salt tank.
6 Lay the salt tank on its side and direct a brisk stream of water from your
garden hose to its inside to rinse out all residue.
7 Using a household scrub brush and a mild soapy solution, clean the salt
plate. This will complete the tank cleaning.
8 Stand salt tank upright. Place brine valve chamber in position and affix with
screws.
9 Insert the brine valve into the chamber and replace brine valve chamber
cap.
10 Fill the salt storage tank with 4 to 6 inches of water.
11 Fill the tank with salt to within a few inches from the top.
12 Replace salt storage tank cover.
6
Hide quick links:
Advertisement
