Advertisement
Before you call for service . . .
If you unexpectedly experience hard water, make these simple checks before
calling your Culligan Man. One of the following conditions may be the reason
for your interruption of service.
IMPORTANT:
If any of the following conditions are found, the water conditioner should be
manually recharged according to instructions on page 7 after you have
corrected the condition.
BLOWN FUSE
Check the house fuse or circuit breaker panel.
Replace a blown-out fuse or reset an open circuit
breaker.
POWER FAILURE
Any interruption in your power supply, or time
changes — such as daylight savings — will disrupt
your conditioner's recharge schedule by causing
the timer to run off schedule. Reset timer to proper
time of day.
POWER SUPPLY
Check your power supply cord. Is it plugged fully
into the electric outlet? Be certain that the outlet
does not have a wall switch which has been turned
off. Reset conditioner to proper time of day and
then plug in.
SALT SUPPLY
Check it. Refill if necessary and wait approximately
four hours for the salt to dissolve before initiating a
recharge cycle.
BY-PASS VALVES
Check to see if they are in the proper position.
Cul-Flo-Valv
by-pass, if used, should be in the "Push
®
for Soft Water" position. If hand valves are used,
see that inlet and outlet valves are opened and
that the bypass valve is closed.
7
Hide quick links:
Advertisement
