Camera; Audio - Clover CDR 4170 Instruction Manual

8.2 CAMERA

This product can be installed up to 4 cameras.
Connect cameras to the VIDEO IN (BNC) on the back panel of the product.
To connect a PTZ camera, connect the PTZ camera's control line to the RS-485 (+, -) terminal
and connect the video output to one out of VIDEO IN on the back panel of the product.
CAMERA (BNC)
VIDEO IN
CH1 CH2
LOOP OUT
A LOOP OUT is a looping output trough VIDEO IN. Therefore the monitor for
NOTE
looping output can be used only when there is video signal on the VIDEO IN.

8.3 AUDIO

The system has one channel audio input and output. If you wish to record and playback audio
signal, connect the proper audio device (microphone) to the AUDIO IN (1 Vp-p @600 ohms) and
speaker to the AUDIO OUTPUT (See illustration below).
V - OUT1 A - IN
CH3 CH4
V - OUT2 A - OUT
ALARM IN ALARM OUT
MODEL NO : CDR4170
AC100-240V,50/60Hz, 25W
_
1 2 3 4 GND +
CLOVER ELECTRONICS
RS485
13073 EAST 166TH STREET, CERRITOS, CA 90703
Factory ID/DHHS CODE : BC
ETHERNET
CAUTION
RISK OF ELECTRONIC SHOCK
DO NOT OPEN
- 41 -
PTZ CAMERA
CLOVER
ELECTRONICS U.S.A
R
C US LITED
E233232
AUDIO/VIDEO EQUIPMENT 2UW2
POWER
ATTENTION
RISQUE DE CHOC ELECTROIQUE
NE PAS ENLEVER
AC INPUT
AC100-240V,50/60Hz