Mounting Components; Main Unit; Siren; Antenna - Clarion UNGO MS8200 Installation Manual

Mounting Components

Main Unit

The main unit should be mounted in the interior of the vehicle. Do not mount the main unit
in the engine compartment. For maximum security, avoid mounting the main unit where it
will be easily accessible to a thief.
If you are mounting the unit under the dash board, be sure to mount the unit as high as
possible and in a location where it will not interfere with the operation of the pedals.
Be sure to extend the antenna as high as possible so that optimum range can be achieved.
Before securing the unit, be sure that you have made all of the necessary switch and jumper
selections and perform a thorough function test of the system.
The case of the MS8200 / MS8300 is designed to be mounted using screws, or secured
using wire ties through the wire tie mounting tabs on the bottom of the unit as shown below.

Siren

Mount the siren facing downward and away from sources of heat and face the opening
downward to prevent water from collecting inside the housing. Be sure that the wires are
not easily accessible from underneath the vehicle.
For maximum security, it is best to disguise all under hood system wires with factory style
split loom tubing so that they cannot be easily identified by a thief.
Run all wires from the engine compartment into the interior of the vehicle through a
grommet.
Antenna (MS8200)
Run the antenna as high as possible in the vehicle. Best operation range will be achieved
when the antenna is run vertically, pointing upward. Avoid running the antenna along any
existing wire harnesses and route away from metal surfaces.
MS8200 / MS8300 Installation Manual - Page 3