Mounting Components - Clarion Ungo MS2004 Manual

Mounting Components

Main Unit
The main unit should be mounted in the interior of the vehicle. Do not mount the main unit in the engine compartment. For
maximum security, avoid mounting the main unit where it will be easily accessible to a thief.
If you are mounting the unit under the dash board, be sure to mount the unit as high as possible and in a location where
it will not interfere with the operation of the pedals.
Be sure to extend the antenna as high as possible so that optimum range can be achieved.
Before securing the unit, be sure that you have made all of the necessary switch and jumper selections and perform a
thorough function test of the system.
The case of the MS2004 is designed to be mounted using screws, or secured using wire ties through the wire tie mounting
tabs located on the unit.
Siren
Mount the siren facing downward and away from sources of heat and face the opening downward to prevent water from
collecting inside the housing. Verify that the override key switch located on the back of the siren can be easily accessed.
Be sure that the wires are not easily accessible from underneath the vehicle.
For maximum security, it is best to disguise all under hood system wires with factory style split loom tubing so that they
cannot be easily identified by a thief.
Shock Sensor
The dual stage, electronic shock sensor, included with the system, is designed to be mounted in the interior of the vehicle
using a tie wrap or double sided tape. Be sure to avoid mounting the sensor to sources of strong electrical interference
such as cellular phone transceivers or the vehicle's engine computer.
Suggested mounting locations are an air conditioning duct, or a dashboard or center console support brace.
Override Switch
Mount the Override Switch in a location near the driver where it is easily accessible but not plainly visible. Plug the blue
override switch connector into the blue 2-pin socket on the main unit.
Be sure that the switch cannot accidentally be pressed or damaged by movement of passengers or contents within the
vehicle.
LED Status Indicator
Mount the status LED so that it is visible from both sides of the vehicle. Plug the red LED connector into red 2-pin socket
on the Main Unit.
Antenna
Mount the extended range antenna vertically on the front windshield near either side pillar for best operation. Be sure that
this area is clean and free of any metallic window tint film. In certain vehicles such as those equipped with a heated
windshield or a built-in windshield defroster, the antenna should be mounted on a rear or side window. Mount the antenna
at least 2 inches below the roofline.
MS2004 Installation Manual- Page 2