In Case Of Difficulty - Clarion DXZ865MP Owner's Manual

9. IN CASE OF DIFFICULTY

Problem
Power does not
Fuse is blown.
turn on.
(No sound is
produced.) Incorrect wiring.
No audio when Amplifier turn-on lead is
operating the unit shorted to ground or
with amplifiers. excessive current is required.
Nothing happens The microprocessor has
when buttons are malfunctioned due to noise,
pressed. etc.
Display is not DCP or main unit connectors
accurate. are dirty.
No sound heard. The speaker protection
circuit is operating.
No sound heard. There is a disc other than a
compact disc or foreign
matter already in place.
MP3/WMA files are absent in
a disc.
Files are not recognized as
an MP3/WMA file.
File system is not correct.
Sound skips or is
Disc is dirty.
noisy.
Disc is heavily scratched or
warped.
Sound is cut or MP3/WMA files are not
skipped. encoded properly.
Noise is
generated or
noise is mixed
with sound.
Cause
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Turn the unit off and check each wire for a possible
short. If the amplifier turn-on lead shorts out, cover it
with insulation such as tape.
Turn off the power, then
remove the DCP by
referencing "Removing
the DCP" (cf. page 10).
Press the reset button for
about 2 seconds with a
thin rod.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
1. Check the speaker connection.
2. Turn down sound volume. Function can also be
restored by turning the power off and on again.
3. If the sound is muted again, consult your store of
purchase.
With the MOTORIZED FACE open, press and hold
the [Q] button for 3 seconds or longer.
The foreign matter is forcibly ejected.
Write MP3/WMA files onto the disc properly.
Use MP3/WMA files encoded properly.
Use ISO9660 level 1, 2 or JOLIET or Romeo file
system.
Clean the disc with a soft cloth.
Replace with a disc with no scratches.
Use MP3/WMA files encoded properly.
Measure
Reset button
DXZ865MP
41