Hitachi VT-FX980EUKN Instruction Manual page 76

(SATELLITE RECEIVER OPERATION)
Controls
7
Satellite receiver
Type Number
Brand
HITACHI 19
GRUNDIG 19
AMSTRAD 03
CAMBRIDGE 13
PACE 19
NOKIA 23
MASPRO 16
8
PHILIPS 20
TECHNISAT 26
FERGUSON 12
UNIDON 32
9
76
TV Screen
Press the stop
If the programme number of the satellite receiver
I NPUT L 2
=
1 L 1 changes to "12", your satellite receiver can be
2 = L 2
=
3 RF
controlled by this VCR. Press the MENU button to
B RAND 1 2 –A
= NEXT
end programming. If the programme number
=
= = Exit
I NPUT MENU does not change to "12", follow the next
procedure.
Press and release the play
If the satellite receiver programme number still
I NPUT RF – 0 5
=
1 L 1 does not change to "12", press the play
2 = L 2
=
3 RF
button again. Repeat this step until the
B RAND 1 2 –B
= NEXT
programme number changes to "12".
=
TEST
= = Exit If your satellite receiver does not work after
I NPUT MENU
entering the code shown, please try an alternative
code from the table.
Note: With some satellite receivers, the
programme number may not change to "12" even
if the code is correct. Read the instruction manual
of your satellite receiver carefully and set up the
receiver correctly, then perform the above
operation.
After programming the system control code, press
the MENU button to return to normal operating
mode.
Note: This list of satellite receiver brands is a
guide only and does not imply that all models
produced under these brand names can be
operated. It is possible that a particular model
may not work even though the brand name is
listed.
IMPORTANT NOTICE:
The satellite mode must be preset before the VCR
control the satellite receiver. There are 4 common
methods:
a)
b)
c)
d)
button .
There is no need to set the satellite receiver
even though the satellite receiver mode is
power off.
Satellite receiver must be power on.
If the satellite is switchable, set to the 2-digit
programme number indication mode.
Satellite receiver must be power on and set to
the 2-digit programme number indication
mode.
button.