Hitachi VT-FX980EUKN Instruction Manual page 12

(AUTO INSTALLATION FUNCTION)
VCR
7
COMMERCIAL ADVANCE
REC/
PROG
8
COMMERCIAL ADVANCE
PROG
9
VIDEO LINK
CA
VIDEO LINK
Safety Tab
12
TV
REW
FWD
TAPE
NAVIGATION
IRT
REW FWD
TAPE
NAVIGATION
REC/
IRT
REV FWD
TAPE
NAVIGATION
COMMERCIAL ADVANCE
REC/
IRT
PROG
If you cannot tune your TV correctly to the test
signal, or if there is distortion in the signal, it may
be necessary to change the VCR RF channel.
In this case, press the PROG select button (
) on the VCR to change the VCR RF channel, and
then retune your TV. If the test signal does not
improve, continue to change the VCR RF channel
and retune your TV until a clear test pattern is
received. If the STOP button on the remote control
or on the VCR is pressed, the RF from the VCR
will be turned off.
The VCR RF channel will change as follows:
6
Press the play/still (
will disappear and the VCR will now come out of
standby mode into operate mode.
You should now be able to playback a
prerecorded cassette.
Insert the cassette carefully (see page 21 for
CASSETTE TAPES). If the safety tab is removed
then playback will start immediately. If not, press
6
the play/still ( ) button and the picture will
appear on the screen.
or
) button, the test pattern