Hitachi VT-FX980EUKN Instruction Manual page 54

groups during replay of a recorded television broadcast.
Press the CA button on the remote control handset. The CA indicator on the VCR will be lit.
1
Play the tape with commercials in it.
2
OPERATE VCR/TV AUX
PROG
TV
PROG
MENU MOVIE TEXT
NAVI
CA
CA
ENTER
REC INDEX
REV FWD
Notes:
3
following conditions:
• Tape Navigation is set to ON.
• Playback the self-recorded tape.
• The recording is made from antenna input.
• The channel to record in not BBC1 or BBC2.
Operating notes:
• If a power failure has occurred during
recording,
operate correctly.
•
accurate, it is normal for some commercials
is to not be skipped.
• If you press the play or rewind button during
How to override
Even when CA is set to ON, automatic skipping can be temporarily suspended (overridden). You
may override skipping by pressing PLAY or STOP while a commercial group is being automatically
skipped. If you wish to view that commercial group, you may reverse the tape back to a point
before the commercial group started and press PLAY. This time, when the start of the commercial
goup is found, the group will not be automatically skipped. Automatic skipping will be re-enabled
after the VCR detects the end of the commercial group.
54
allows the VCR to automatically or manually skip past detected commercial
DEO LINK
COMMERCIAL ADVANCE
PROG
CA
VIDEO LINK
CA indicator
will operate in the
may not
is not 100%
the feature will be
(i) Commercial Skip
(a) When the VCR detects the commercials, the
VCR will fast forward the tape to the end of the
commercial and continue to playback.
PLAY AUTOMATICALLY CUE
prog cm
Note: During this commercial skip or cue mode
the CA indicator will be alight.
(b) To initiate a manual skip to the end of the next
TAPE
commercial group with the
NAVIGATION
REC/
IRT
forward search (F.FWD button). The skipping will
terminate as shown below.
(ii) During commercial skip or cue mode with
will change to playmode, if VCR detects the
following parts:
(a) END OF CM
prog cm cm
(b) Beginning of next programme
CUE
prog A
the following conditions:
• CA is set to OFF (front panel light not on).
• Tape Navigation is set to OFF .
• Playback of tapes not recorded on this VCR.
• When selected input either L1 or L2 or L3 input.
• Tape NAVI data for this tape has been deleted.
• Commercial detection was not on during
recording (as listed above).
turn off during this commercial break.
•
programme which is dark and or quiet.
•
commercials groups which are less than 55
seconds in total length.
•
commercials.
PLAY
cm cm cm
switched to on, press
function on, the VCR
CUE PLAY
cm cm
PLAY
prog B
will not operate in
may skip part of a
will not skip
will not skip single
prog
prog