Panasonic TOUGHBOOK CF-18NHHZXBM Service Manual page 42

! Line Processing of Main Unit
Tape
MAIN PCB
Connect it first when
setting the Main Board.
Then attach the Coin Battery
to the Top Case.
Connect the FFC.
! Line Processing of the Lithium Battery
Lithum Battery
Connect the Cable to the Connector CN3 of the Board.
(Right angle type)
CN3
Cushion for Lithum Battery
Attach on the IC14 (Super I/O).
Attach the white adhesive surface to the IC side.
Screw
HDD Guide Plate
Between the Main Board
and the Top Case
Bat Con Angle
After connecting
Then insert the
the FFC, shape
shaped part to the
it over the Board.
BAT Connector.
After attaching the Cushion for Lithum Battery,
set the Lithum Battery as shown below.
Attach the Lithum Battery on the Cushion.
Draw the Lead Wire toward the end of the Board.
Arrange the surplus length of the Lead Wire
as shown below.
Screw(D Sub)
Screw
Screw
Safety Working
When inserting,
Screw
use the jig to receive
the Cable.
Screw
0~0.5mm
Bat Cushion
0~2mm
FFC CN
Stopper
Screw
Safety Working
End of the Board.
7-23
Screw
I/O PCB ASSY
Safety Working
Connect.
Insert the surplus
length between the Modem
Connector and
the LAN Connector.
Modem
Connector
LAN
Connector
White
Avoid running over
the Modem Connector
and the LAN Connector
(yellow area).
Screw
MAIN PCB
Main PCB Switch
0~0.5mm
Match to
Attach before
the edge
setting
of the
the Main PWB.
Board. Tape
Wipe off using alcohol
before attaching.
FFC Spacer
Pass the Lead Wire through
the notch of the Board.