Panasonic TOUGHBOOK CF-18NHHZXBM Service Manual page 31

7.2.4. Setting up the LCD Hinge
1. Wind the Cable coming out of the LCD Unit conterclock-
wise to the LCD Hinge.
2. Set the Lock Plate and the Hinge Top Cover, and rotate
the LCD Hinge to turn the Display Unit to front
3. Put the LCD Cable and the Antenna Cable in the Cable
Holder.
4. Fit another Cable Holder and clamp the Cable Holders in
the LCD Hinge.
5. Fix the LCD Hinge using the 2 Screws <Y> and the 2
Cable Holder Plates.
Screws <Y> : DXYN3+J8FNL
! Assembly of LCD Hinge
Initial condition of LCD Hinge.
The direction which can rotate
Safety Working
Ensure it comes
over the Cable Hold Tape.
Not necessary if the Cable
is not passed under
the Cable Hold Plate.
Cable Hold Plate
Screw<Y>
A
LCD Hinge
Using the fixing jig when fixing the Hinge
Tighten.
Fix.
If you arrange the Cable in the area,
you do not need to use the fixing jig.
Cable Holder
Plate
Ensure the "C" side
comes to the lower
right corner when
viewing from above.
Safety Working
Avoid catching the Cable.
Screw<Y>
Be free of pinching cables.
Avoid running over
the Hinge and the rib.
Cable Hold Plate
Tighten.
Avoid catching the Cable (when repairing or when not using the jig).
Temporarily fix the both sides ("A") of the Hinge using
the Screw <W>, and fix the Cable Hold Plate.
After fixing the Cable Hold Plate, remove the Screw <W>
from the both sides ("A").
Cable Hold Plate is installed after it is kept in A
temporarily.(using Screw<W>)
7-12
Cable
<Y>
Holder
Cable
<Y>
Plate
Holder
Plate
LCD
Hinge
Cable
Holder
LCD Cable
Holder
Sheet
Cable
Holder
A