Panasonic TOUGHBOOK CF-18NHHZXBM Service Manual page 41

7.2.10. Setting the Main PCB and the Lithium Battery
1. Set the PCMCIA Unit to Main PCB
2. Mount the HDD Guide Plate and set the Main PCB.
3. Fix the Main PCB using the four Screws <N> and the two
Screws <M>.
4. Fix the Main PCB using the Screw <L>.
5. Connect the seven Cables to the corresponding Connec-
tors (CN9,CN12,CN14,CN23,CN30,CN35,CN36).
6. Turn the computer over and connect the two Cables to
the corresponding Connectors (CN8, CN17).
7. Connect the Cable to the Connector (CN3), and fix the
Lithium Battery.
Screw <L>:DRSB2+5FKL
Screws <M>:DXYN2+J12FNL
Screws <N>:DXYN2+J18FNL
! Line Processing of the Antenna Cable
Tape
Use the Tape only for
the position with the
Antenna Cable.
Avoid running over
the Connector
and the bis.
Antenna Cable
(blue)
Sub material:
PET TAPE 1
(19 mm width x 3 cm)
Sub material is not
necessary if the Tape
and the Cable Holder
(CAP) are not used.
Cable Holder(Cap)
Details for attachment
Attach as shown above
to avoid coming off.
Draw it out of the cabinet.
Antenna Cable (Gray)
If no Gray Cable, use
the Brown Cable.
0~2mm
Tape
Safety Working
Draw it out of the cabinet.
HDD Guid Plate
Connector (CN36)
<N>
Connector
(CN23)
Main PCB
Connector (CN35)
Connector (CN30)
PCMCIA Unit
Draw it out of the cabinet.
Antenna Cable
(black)
Screw
Pass it between
the bosses.
Heat Dissipation
Rubber
Avoid running
0~2mm
over the boss.
0~1mm
Pass it beside
Tape
)
the pin.
1~2mm
Screw
Heat Dissipation Rubber
7-22
Lithium Battery
<M> <M>
<L>
Connector (CN17)
Connector (CN8)
<N>
Connector (CN3)
Connector (CN9)
Connector (CN14)
LAN Cable
<N>
Connector (CN12)
<N>
to Connector (CN17)
to Connector (CN8)
Screw
CPU Heat Plate
Arrange the Cables,
and then set it.
Draw it out of the cabinet.
0~1mm
Antenna Cable
(white)
Match the left end to the marking line.
Fit it lengthwise in the frame.
(0 to 0.5 mm from the
end of the cabinet)
Check a position of
power swich knob.(right)