Panasonic TOUGHBOOK CF-18NHHZXBM Service Manual page 28

! Assembly of Inverter PCB (Applicable Model : Digitizer Model)
Inverter Assy
LCD Rear Side
Pay attention to the direction of
the INVERTER PCB when doing
this installation.
Inverter
Case MIL
5~6mm
LCD Cable
Connector side
INV Sheet 1 Inverter
(Black)
5~6mm
INV Sheet 2(Translucence)
CCFL Connector side
! Assembly of Touch Screen (Applicable Model : Touch Screen Model)
Attach the surface to the LCD Front.
Be free of overhang..
Touch Screen Assy
Safety Working
LCD Side Cushion E
INV MIL Cover
Detail of "A"
Safety Working
Insert
Confirm a
"ANT Cable Cushion"
isn't frayed.
Insert
1~2
mm
Protect Sheet
Remove it parallel to the Touch Screen.
Attach the surface
OK
Laminate film
at the center of
the display.
(Using the jig)
Touch Sreen Dimensional tolerance
:–0.2
NG
Laminate film
Touch Sreen
Avoid any stress on the Cable
when connecting it to the Inverter.
(Hold the Connector part
when connecting/disconnecting.)
LCD Side Cushion F
Insert between the ribs.
Insert between
the ribs.
Tape
Attach so the Inverter Assy
Connect the Cable to the left
comes at the center.
and right Connectors.
(Top/Bottom: -2 to +2 mm,
Left/Right: -3 to +3 mm)
Carefully attach Tape.
Tape
Inverter Assy
LCD Back Dumper
Sield Sheet
LCD Cable
pasted on the connector
Safety Working
after it is wound around
the cable twice.
Insulation Parts
Avoid getting under the Sheet.
A
6–2mm from
the branch point
ANT Cable Cushion
Don't give stress to LCD TAB.
Avoid any stress on the TAB
Wrap.
part of the LCD Module.
Touch Screen Assy
TS Spacer B
TS Spacer A / TS Spacer B:
Don't get into a LCD indication range.
TS Spacer A
0~1mm
7-9
Avoid any stress on the Cable
when connecting it to the Inverter.
(Hold the Connector part
when connecting/disconnecting.)
LCD Side Cushion E
Insert between the ribs.
Caution High Voltage Label
0~3mm
Inverter Assy
0~0.5mm
PET Tape2
Match to the
left end of
0~0.5mm
the square
hole of the
Connector.
0~3mm
Conductive Tape
Wrap over the Antenna Cable
Cushion and the Cable.
A
Detail of "A"
Back side
6–0.5mm
0~0.5mm
Touch
0~0.5mm
Screen
Place this to the wall of cabinet.
TS Spacer A
0~1mm 0~1mm
TS Spacer B
0~1mm
TS FPC
Spacer
–0.5mm
Fit this to the
line of cabinet.
LCD Side
Cushion B
–0.5mm
Fit this to the
line of cabinet.