X, Result Code Selection And Call Progress Monitoring Control - Motorola G24 Guide Developer's Manual

Modem Configuration and Profile
Example
ATE?
001
OK

X, Result Code Selection and Call Progress Monitoring Control

This command defines the CONNECT result code format. It determines whether or not the G24
transmits particular result codes to the user. It also controls whether the G24 verifies the presence
of dial tone when it first goes off-hook to begin dialing, and whether the engaged tone (busy
signal) detection is enabled.
Command Type
Set
Read
Test
The following table shows the X parameters.
<Parameter>
<value>
Example
ATX?
000
OK
3-276
Syntax Response/Action
ATX<value> OK
or:
+CME ERROR: <err>
ATX? <current value>
Table 3-184: X Parameters
0 CONNECT result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Disabled
1 CONNECT <text> result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Disabled
2 CONNECT <text> result code given upon entering online data state:
Dial tone detection - Enabled
Busy detection - Disabled
3 CONNECT <text> result code given upon entering online data state:
Dial tone detection - Disabled
Busy detection - Enabled
4 CONNECT <text> result code given upon entering online data state:
Dial tone detection - Enabled
Busy detection - Enabled
The default value is 0.
AT Commands Reference Manual
Remarks
The Set command sets the result code
and call progress monitoring control.
The Test command for X is not defined
by ITU, and therefore is not supported
by the G24. The G24 returns an error.
Description
December 31, 2007