+MMAR, Motorola Mark As Read
This command handles changing the <stat> attribute of an SM in the G24 memory location
<index>, preferred message storage <mem1>, from "REC UNREAD" to "REC READ".
(<mem1> is selected using the +CPMS command.) If the status change fails, +CMS ERROR:
<err> is returned.
Command
Type
Set
Read
Test
The following table shows the +MMAR parameters.
Example
AT+MMGR=1
+MMGR: "REC UNREAD","+972544565034",,"04/11/04,09:48:36+08"
message text
OK
AT+MMAR=1
OK
AT+MMGR=1
+MMGR: "REC READ","+972544565034",,"04/11/04,09:48:36+08"
message text
OK
+CMSS, Send Message From Storage
This command sends a pre-stored message, written previously using the +CMGW command. The
<da>, <toda> parameters are optional. If a DA is given, the message is sent to that address.
Otherwise the message is sent to the DA it was stored with (if any was entered). If no DA is
found, an error occurs.
December 31, 2007
Syntax
Response/Action
+MMAR=<index>
OK
or:
+CMS ERROR: <err>
Table 3-72: +MMAR Parameters
<Parameter>
<index>
Index of the message to be marked as read, in
the SMS memory.
AT Commands Reference Manual
Chapter 3: AT Commands Reference
Remarks
The Read command for +MMAR is
not defined, and therefore is not
supported by the G24. The G24 returns
an error.
The Test command for +MMAR is not
defined, and therefore is not supported
by the G24. The G24 returns an error.
Description
3-125