Auto Tensioner Setting; Timing Belt Installation - Mitsubishi 6A1 series User Manual

11A-4-4
MD998754
MB990767
(B)
Timing mark
E
Mitsubishi Motors Corporation
6A1 ENGINE (E - W) -
6AE0048
"BA AUTO TENSIONER SETTING
(1) Set the auto tensioner in a vice, while making sure it
(2) Slowly close the vice to force the rod in until the set
(A)
6AE0049
(3) Insert a 1.4 mm wire in the set hole.
(4) Remove the auto tensioner from the vice.
6AE0050
"CA TIMING BELT INSTALLATION
(1) Turn the crankshaft sprocket so that its timing mark will
6AE0329
(2) Bring the timing marks of the camshaft sprockets as shown
6AE0358
Feb. 1997
Timing Belt
is not tilted.
hole (A) of the rod is lined up with the set hole (B) of
the cylinder.
be away from the mating timing mark by approx. three
teeth.
Caution
D
If the timing marks are aligned, the piston is
brought to the TDC. When the camshaft is turned
under this condition, the valves may interfere with
the piston.
in the illustration.
PWEE9622