More Cycles - Maytag Neptume MD98 Use & Care Manual

M
C
ORE YCLES
More Cycles offers the ability to choose "wrinkle release", "freshen up", and "dryel" cycles.
S W
ETTING RINKLE
"wrinkle release" – will release wrinkles from items that are clean and dry but slightly wrinkled, such as from a crowded closet or
suitcase or from sitting in the dryer too long after the end of the cycle. It provides 8 minutes of heated tumbling and 10 minutes of
cool down tumbling without heat.
Home
sensor dry
air fluff
time dry
(no heat)

more cycles

favorites
Step 1
Touch "more cycles" on the
Home screen.
Press "Start/Pause" or
change your selection below.
Time
options
wrinkle release
18
18 minutes
minutes
continue
regular
temperature
Touch the up or down arrow to
set the time to tumble. The time
will increase or decrease by one
minute increments. Press
"continue" when done.
S F U
ETTING RESHEN
"freshen up" – the "freshen up" cycle is designed to activate a fabric softener sheet. There are 5 minutes of heated tumble
followed by 10 minutes of tumble in unheated air.
Home
sensor dry
air fluff
time dry
(no heat)
favorites
more cycles
Step 1
Touch "more cycles" on the
Home screen.
R
ELEASE
More Cycles
wrinkle release
freshen up
Step 2
Select "wrinkle release".
Press "Start/Pause" or
change your selection below.
Temperature
wrinkle release
18 minutes
regular
delicate
regular
temperature
Touch the appropriate
temperature for the load.
P
More Cycles
wrinkle release
freshen up
Step 2
Add a fabric softener sheet to the
load. Select "freshen up".
wrinkle release
®
Dryel
Step 3
Review Screen – The default settings for "wrinkle
release" are 18 minutes of tumbling using regular
temperature heated air. You may press Start/Pause to
begin or select any of the areas on the touchscreen to
further customize the "wrinkle release" cycle.
options
wrinkle prevent
medium
extra low
remind chime
Options Screen – The following options may be added
to customize your "wrinkle release" cycle:
• "wrinkle prevent"
• "end of cycle chime"
• "remind chime"
See page 7 for a detailed description of these options.
When the desired selections are made, touch
"continue" to see the review screen once again.
®
Dryel
Step 3
Review Screen – The default settings for "freshen
up" are 15 minutes of tumble using extra low
temperature heated air. You may press Start/Pause to
begin or select any of the areas on the touchscreen to
9 further customize the "freshen up" cycle.
Press "Start/Pause" or
change your selection below.
options
18 minutes
regular
temperature
Options
loud end
of cycle chime
on off
continue
on off
Press "Start/Pause" or
change your selection below.
options
freshen up
15 minutes
extra low
temperature