More Cycles - Maytag NEPTUNE MD98 Use & Care Manual

M
C
ORE YCLES
More Cycles offers the ability to choose "wrinkle release", "freshen up", and "dryel" cycles.
S W
ETTING RINKLE
"wrinkle release" – will release wrinkles from items that are clean and dry but slightly wrinkled, such as from a crowded closet or
suitcase or from sitting in the dryer too long after the end of the cycle. It provides 8 minutes of heated tumbling and 10 minutes of
cool down tumbling without heat.
Step 1
Touch "more cycles" on the
Home screen.
Touch the up or down arrow to
set the time to tumble. The time
will increase or decrease by one
minute increments. Press
"continue" when done.
S F U
ETTING RESHEN
"freshen up" – the "freshen up" cycle is designed to activate a fabric softener sheet. There are 5 minutes of heated tumble
followed by 10 minutes of tumble in unheated air.
Step 1
Touch "more cycles" on the
Home screen.
R
ELEASE
Step 2
Select "wrinkle release".
Touch the appropriate
temperature for the load.
P
Step 2
Add a fabric softener sheet to the
load. Select "freshen up".
Step 3
Review Screen – The default settings for "wrinkle
release" are 18 minutes of tumbling using regular
temperature heated air. You may press Start/Pause to
begin or select any of the areas on the touchscreen to
further customize the "wrinkle release" cycle.
Options Screen – The following options may be added
to customize your "wrinkle release" cycle:
• "wrinkle prevent"
• "end of cycle chime"
• "remind chime"
See page 7 for a detailed description of these options.
When the desired selections are made, touch
"continue" to see the review screen once again.
Step 3
Review Screen – The default settings for "freshen
up" are 15 minutes of tumble using extra low
temperature heated air. You may press Start/Pause to
begin or select any of the areas on the touchscreen to
9 further customize the "freshen up" cycle.