Reference Position - Starting The Sewing Cycle - Quick Stop - DURKOPP ADLER 745-34 Speedpocket Operating Instructions Manual

2.11 Reference position - Starting the sewing cycle - Quick stop

26
Reference position
The reference position is necessary in order to get a defined initial
position.
–
Switch the main switch on.
The control is initialized.
–
The display shows briefly
bF4 (Program version) 745 (Program number)
–
The control checks whether the transport carriage is in its rear end
position.
If not, the message "Reference run" is shown on the screen.
r E F
–
Step back on the pedal.
The reference run starts.
The transport carriage runs in its rear end position.
–
The display changes over to the seam program set before
(e.g. L1 -180 mm).
Starting the sewing cycle
–
Step forward on the pedal.
By repeated stepping on the left pedal the various steps of the
positioning sequence are started sequentially.
–
For positioning corrections:
Step back on the pedal.
The last step of the positioning sequence is undone.
A new positioning can be made.
–
Step forward on the pedal.
The sewing cycle is started.
Quick stop
The safety system of the 745-34S offers two possibilities for an
immediate shut-down of the sewing unit in case of faulty operation,
needle breakage, thread breakage etc.:
–
Step back on the pedal.
The current step of the positioning sequence or the sewing cycle
respectively is stopped immediately.
The following message appears:
E r r 9 6 0 1
–
Step back on the pedal again.
The carriage runs out of the feeding area.
–
Press key "RST" on the control panel.
The current sewing cycle is stopped.