Carriage Unit Removal - Epson Stylus 800 Service Manual

3.2.5.4
[Step 1] Remove the printer mechanism (Refer to section 3.2.4.)
Remove the tension spring that holds the CR motor in place. Then take the timing belt out
[Step 2]
of the CR motor drive pulley and the driven pulley.
Remove the ground spring plate on the left side.
[Step 3]
Rotate the shaft holder that holds both ends of the carriage guide shaft, and push the ends
[Step 4]
inward to disengage them from the left and the right frames of the printer mechanism.
Remove the FFC cables that go through the base frame assembly.
[Step 5]
Remove the carnage unit along with the carriage guide shaft.
[Step 6]
Paper Gap Adjustment (Chapter ~ Section 4.4)
3-12
Shaft Holder
Figure 3-11. Carriage Unit Removai
Rev. A