Pump Unit Removal - Epson Stylus 800 Service Manual

3.2.5.2

Pump Unit Removal

[Step
Remove the printer mechanism. (Refer to section 3.2.4.)
1]
[Step 2] Move the carriage to the middle of the printer. The carriage is located between the first
and second paper guide rollers, as illustrated in the figure below.
[Step 3]
Remove 2 screws (CBB (M3 x 10)) attaching the front paper guide assembly to the
mechanism.
[Step Lift the front side of the carriage and hold it. Lift the left end of the front paper guide
4]
assembly slightly, and then lift the right end. Take out the front paper guide assembly by
pulling it toward you.
Insert a piece of paper between the printhead and the printer mechanism to protect the
[Step 5]
surface of the printhead from being darnaged.
Push the pump unit inward by releasing the tab securing the pump unit to the holder
[Step 6]
plate. At the same time, release the tab at the bottom of the pump unit. Then take the
pump unit out of the printer mechanism.
Rev. A
Figure 3-8. Pump Unit Removal
uide Assembly