11.2.3 Angle Position of the Burner
38
The burner 4 must be at an angle of approx. 90° to the thread
positioned by the thread deflector 3.
1
2
Caution Risk of Injury !
Turn the main switch off.
Set the angle position of the burner only with the main switch turned
off.
–
Remove the finger guard 2 after loosening the mounting screws.
The clamping screws 1 are readily accessable.
–
Loosen the clamping screws 1 slightly.
–
Set the correct angle position by swinging the burner.
–
Tighten clamping screws 1.
–
Attach the finger guard 2 again.
Caution Risk of Injury !
After completing the setting work it is essential that the finger guard be
attached again.
90°
3
4