Aligning The Air Nozzles For Cleaning The Reflected Foil - DURKOPP ADLER 745-34-2 Installation Instructions Manual

7.3

Aligning the air nozzles for cleaning the reflected foil

80
2 1
The light barrier fixture is equipped with additional air nozzles for
cleaning the reflected foils from dust and fluff.
Standard checking
The air nozzles 1 have to be aligned in such a way that the air stream
is directed towards the reflected foils while the feeding clamp moves
in loading position.
Precondition: The feeding clamps are aligned to the folder sole
(see chapter 4.4).
Correction
–
Select the output element y3 in the multitest system.
–
Pull up the feeding clamps in the air nozzle area and lower
with yc104 / yc105.
–
Slightly loosen the screws 2 and turn the air nozzle holder in such
a way that the air stream hits the reflected foil - be careful not to
displace the light barrier position.
–
Consider the lateral displacement of the left clamp in the mode
"Pocket bag on flap". For this purpose select the output element
yc106 additionally.
–
Tighten the screws 2 again.
2 1