Char-Broil 12301388 Product Manual page 10

Attach two Spacers and Lid Handle to Grill Lid using two
1/4-20x2 ½"Machine Screws, Insulated Washers, and 1/4-20
Flange Nuts.
Lid Handle
Spacer
Install Temperature Gauge by placing the stem through the
large hole in front of the Grill Lid. Attach the nut provided
until snug against the Lid.
Temperature Gauge
Page 10
Insulated Washer
Insert Vent Knobs into side of Grid Lid from the outside.
Inside the Grill Lid, slide a Vent Plate onto the Knob stud
followed by a Vent Spring and a #10-24 Hex Nut.
Tighten just enough to allow Vent to slide freely from side
to side.
Repeat for other side.
Vent Plate
Vent Spring
Attach the Logo Plate by inserting the two pins into the
small holes on the front of the Grill Lid.
From the inside of the Lid, press the Logo Plate Clips onto
the pins until they are snug against the Lid.
Vent Knob
Logo Plate