V810 Operating Panel Key - DURKOPP ADLER 767 Instruction Manual

7.1 V810 Operating Panel Keys
C
1
Key Function
P Start or end programming mode
E Confirm a parameter-value change
+ Increase a displayed parameter value
- Decrease a displayed parameter value
1 Starting bar tack or starting stitch condensation
2 Ending bar tack or ending stitch condensation
3 Auto foot lift on stop in mid-seam
3 Auto foot lift after thread trimming
4*** Basic needle position (UT/OT)
A* Key for bar tack suppression or activation
B** Key for needle up/down or shift-key
in programming mode
Symbol Function
C Automatic rotation speed active
D Light barrier switched on
E Machine running
F Limited rotation speed active
* Other functions possible (see parameter 293)
** Other functions possible (see parameters 294)
*** Other functions possible (see parameters 291) e.g.
"A" key parameter F-293-18
"B" key parameter F-294-18
D E
2 3
F G
4 A B
Settings
SINGLE / DOUBLE / OFF
SINGLE / DOUBLE / OFF
ON / OFF
ON / OFF
POSITION 1 / POSITION 2
GB
21