Setting The Parameters Values With The V810 Control Panel - DURKOPP ADLER 767 Service Instructions Manual

17.2 Setting parameter values with the V810 control panel
Changing technician-level parameter values
Entering the technician-level code number
–
Turn off the main switch.
–
All plugs must be plugged in to the sewing-drive control.
–
Press and hold down the "P" key.
–
Turn on the main switch. "C-0000" appears in the display.
–
Release the "P" key.
Enter code no. 1907. Press the "+" or "-" keys to alter the value of
–
the flashing digit. Press the ">>" key to move to the next digit.
Press the "E" key. The first technician-level parameter F-100 is
–
displayed.
Selecting parameters and changing values
–
Press the "+" and "-" keys to select the next or preceding parameter.
–
The parameter can be entered direct with the ">>", "+"and "-" keys.
–
Press the "E" key. The value of the selected parameter is displayed.
–
Press the "+" and "-" keys to change the parameter value.
–
Press the "E" key to display the next parameter or the "P" key to
display the same parameter.
Saving changed parameter values
–
Press the "P" key to terminate programming.
–
Sew a complete seam, i.e. push the pedal forward and then fully
back. The change is saved.
–
If no seam is sewn, the change is lost.
–
Press the "P" key again to return to programming level.
–
Changing manufacturer-level parameter values
Entering the manufacturer-level code number
–
Turn off the main switch.
–
All plugs must be plugged in to the sewing-drive control.
–
Press and hold down the "P" key.
–
Turn on the main switch. "C-0000" appears in the display.
–
Release the "P" key.
Enter code no. 3112. Press the "+" or "-" keys to alter the value of
–
the flashing digit. Press the ">>" key to move to the next digit.
Press the "E" key. The first manufacturer-level parameter F-200 is
–
displayed.
Continue as for "Selecting parameters and changing values"
–
GB
75