11.5.7
Connecting the sewing light on the DA321G control unit
2
6
5
1
–
Loosen the four screws on the front plate of the control unit.
–
Take off the front plate.
–
Push the cable from the rear through the cable duct 1 in the
controller.
–
Take off the black rubber guide track 2.
–
Use a screwdriver to punch though the circular opening in the
guide track.
–
Guide the cable for the sewing light transformer through this new
opening.
–
Replace the guide track.
–
Use a thin screwdriver to press on the terminal openings 4 and 3.
This opens up the terminals 5 and 6.
–
Connect the blue cable to terminal 6 and the brown cable to
terminal 5.
–
Reattach the front plate using the four screws.
6
5
4
3
GB
37