Adjusting The Working Height Of The Mg 55-3 Stand - Duerkopp Adler 669 Instruction Manual

4.

Adjusting the working height of the MG 55-3 stand

Caution: Risk of injury !
Ergonomic-related, operator injuries can result if the stand height is not
adjusted to fit the operator.
–
The working height is adjustable between 750 mm and 900 mm
(measured to the upper edge of the table plate).
–
Loosen the screws 1 in the stand spars.
–
Adjust the table plate vertically to your required height.
Be sure to adjust (pull out and push in) both sides of the table plate
equally so that it does not tilt.
–
Tighten screws 1.
1
GB
15