Mg 53-3 Frame; Assembling The Frame Components; Assembling The Table Plate And Mounting It On The Frame; Adjusting The Working Height - Duerkopp Adler 69 Installation Instructions Manual

3.2

MG 53-3 frame

3.2.1

Assembling the frame components

– Assemble the frame components as shown in the illustration.
– Fit the four frame feet 13.
– Slightly undo the screws 12 on both sides of the cross-braces 14 and ensure that
the frame is stable.
All four of its feet must be in firm contact with the floor.
3.2.2

Assembling the table plate and mounting it on the frame

– Hammer the support 2 into the hole in the table plate 3.
This supports the upper part when it is folded back
– Screw the wooden drawer 5 with its guides on the left under the table plate 3.
– Screw the motor-protection switch 11 with its attachment bracket under the table
plate 3.
– Screw the cable channel 10 behind the motor-protection switch 11 under the table
plate 3.
– Screw the holder 9 for the mains-lead cleat behind the cable channel 10 under
the table plate 3.
– Screw the sewing-light transformer 4 (optional extra) under the table plate 3.
– Pass the mains cable from the motor-protection switch 11 through the cable
channel 10 and holder 9.
– Pass the connection cable of the sewing drive and the sewing-light
transformer 4 from the motor-protection switch 11 through the cable channel 10.
– Attach table plate 3 to the frame with timber screws (B8 x 35).
Its alignment on the frame can be seen from the dimensions in the sketch.
– Insert the reel stand 8 in the hole in the table plate 3 and secure it with nuts and
washers.
Fix and align the reel holders and unwinding arms.
The reel holders and unwinding arms must be vertically in line.
– Screw the oil-can holder 7 to the left-hand frame upright.
– Screw reel holder 1 to the table plate 3 (only when fitted with ribbon binder,
sewing attachment E4 or E5).
3.2.3

Adjusting the working height

The working height is adjustable between 750 and 840 mm (measured to the upper
edge of the table plate).
– Undo screws 6 on both frame uprights.
– Adjust table plate 3 to the desired working height and ensure it is level.
To avoid tilting pull the table plate 3 out or push it in equally at each side.
– Tighten screws 6.
7