Mounting The Table And Pedal Extension (Optional Equipment); Mounting The Table Extension - Duerkopp Adler 609 Instruction Manual

5.

Mounting the table and pedal extension (optional equipment)

5.1 Mounting the table extension

10
Mount the table extension according to the sketch below:
Preassembling the bracket
–
Preassemble the bracket according to the sketch on left.
Preassembling the table extension
–
Turn the table plate upside down and put the insert plate into the
cutout provided for it.
–
Fix the blocks (4x) with screws on the position of the magnets of
the table plate cutout.
–
Adjust the blocks vertically so that the insert plate is always seated
in the table plate cutout but is kept tight enough by the magnets.
–
Fix the supports (4x) with screws on the punch-outs of the table
plate back side.
Attention !
The brackets must rest with the outside edge, not with the bending
radius, against the edge of the recess!