5
4
6
6
3
–
Screw on the drawer 4 with the sockets underneath the left half of
the table plate.
–
Fix the control unit 1 with three woodscrews (5x30) underneath the
right half of the table plate .
–
Screw on the holder for the strain relief of the mains cable
underneath the table plate.
–
Screw the set value initiator 7 onto the mounting bracket (4 screws
M5x10).
–
Fix the bracket with the set value initiator underneath the table
plate with 4 woodscrews (5x30).
–
Screw the cable channel 6 under the table plate.
–
Fix the table plate with woodscrews (6,0x30) on the stand. The
position of the table plate is indicated by the dimensions given in
the sketch.
–
Assemble the pedal linkage 2
–
Hinge the pedal linkage onto the pedal and the set value initiator of
the sewing drive.
–
Adjust the height of the pedal linkage by turning the screw so that
the pedal, when released has an inclination of about 10°.
–
Insert the yarn holder 5 into the hole of the table plate.
–
Hammer the machine head support 3 into the hole on the table
plate.
7
2
1