Duerkopp Adler 609 Instruction Manual page 22

20
Operating and function sequence:
Sewing process
Prior to sewing
Starting position
Position material
for starting the seam.
At the seam start
Sewing
One stitch basting
with attaching stitches
Sewing continuous seam
with attaching stitches
Operation / explanation
- Pedal in rest position
- The machine is at a halt.
- Needle up
- Sewing foot in highest position
- Place the material under the sewing foot
Press the key (bartack/attaching stitches)
B
of the
operating panel.
LED ON: Function bartack/attaching stitches ON.
LED OFF: Function bartack/attaching stitches OFF.
- Prerequisite: on the operating panel
the key has its LED ON
B
- Prerequisite: on the operating panel
the key (one stitch basting)
has its LED ON
- Push the pedal forwards.
- The machine sews attaching stitches
with the bartack speed
- During the attaching of the material
the machine should be fed slightly.
- After attaching, the machine stops
with the thread lever in upper position with
the thread tension open (even if the pedal is
pressed continuously, only the attaching
stitches will be sewn).
- Each time the pedal is pushed forward,
a single stitch will be sewn no matter
how long the pedal is pushed forward.
It is possible to pull any length of
single stitch.
Disabling the one stitch basting function
is only possible after the thread trimming.
- Prerequisite: on the operating panel
the key has its LED ON
B
- Prerequisite: on the operating panel
the key (one stitch basting)
has its LED OFF
- Push pedal forwards and keep it pushed.
- The machine sews attaching stitches
with the bartack speed, then continues
at the speed of rotation set by the pedal.
- Feed the material manually