Fuser Roller Cleaning - Canon IMAGERUNNER 2016 Reference Manual

Fuser Roller Cleaning

If black streaks appear with printing, the fuser roller in the main unit may be dirty.
Should this occur, use the Roller Cleaning function to clean the roller. The roller
should also be cleaned each time the toner cartridge is replaced. Before cleaning
the roller, print out the cleaning pattern. Then load the sheet into the stack bypass
and start cleaning.
IMPORTANT
The cleaning pattern can only be printed on LTR paper.
NOTE
Cleaning the roller takes approximately 100 seconds.
1
Additional Press [Additional Functions] ➞ [
Functions
<ADJUST./CLEANING> appears ➞ press [OK].
If necessary, see the screen shots in steps 1 and 2 of "Automatic Feeder
Cleaning," on p. 7-30.
OK
The <ADJUST./CLEANING> menu appears.
2
Press [
➞ press [OK].
OK
ADJUST./CLEANING
3.FIX.UNIT CLEANING
The <FIX. UNIT CLEANING> menu appears.
3
Press [
press [OK].
OK
FIX.UNIT CLEANING
2.CLEAN PAPER PRT
The cleaning paper is printed. You will use this paper as the cleaning paper.
] or [ ] until <FIX. UNIT CLEANING> appears
] until <CLEAN PAPER PRT> appears ➞
] or [
] or [ ] until
FIX.UNIT CLEANING
1.START CLEANING
CLEAN PAPER PRT
PLEASE WAIT
Routine Cleaning
7
7-33