Table Of Machine-Specific Parameters Of The Da82Ga And 6F82Fa Controls - DURKOPP ADLER 367 Installation Instructions Manual

6.11.3 Table of machine-specific parameters of the DA82GA and 6F82FA controls

Parameter *
F-111 T
F-112 T
T
F-113
F-117 T
T
F-123
F-124 T
T
F-136
F-153 T
T
F-171 **
F-180 ** T
F-182 ** T
T
F-190
F-192 T
T
F-194
F-196 T
* T = technician-level parameter, A = manufacturer-level parameter
** Not the 6F82FA control
The values of the parameters listed below must be changed from their
pre-set values.
The values concerned (x) can be found in parameter sheet
9800 130014 PB52 or 9800 321009 PB52
(in the machine's accessory pack).
Name
upper limit of maximum rotation speed
starting bar-tack rotation speed
ending bar-tack rotation speed
rotation-speed stroke adjustment (DB2000)
bar-tack synchronisation time for ending bar tack
bar-tack synchronisation rotation speed for ending bar
tack
thread-cut stitch backwards/forwards
holding power with the machine at a standstill
needle positions
number of reverse increments
handwheel reverse ON/OFF
thread cutter activation angle
activation delay for thread-tensioner release
activation delay for thread cutter
function of both thread tensioners on sewing-foot lift
Caution !
Great care must be taken when changing parameter values, as an
incorrectly-set drive control may damage the machine!
A master reset restores all parameters to their pre-set values. See
section 6.12.
367
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
29