Panasonic AGHPX255 Operating Instructions Manual page 157

Playback
Cannot play even when
I press the play button.
Images do not appear
on the television even
though I have connected
the camera-recorder
properly.
Cannot hear any sound
from the camera-
recorder's speaker.
Cannot perform hot
swap playback.
Cannot perform clip
recording.
Other
Cannot read the data on
the SD memory card.
The remote control does
not work.
There is a rattling sound
when the camera-
recorder is tilted back
and forth.
A clicking sound is
heard when the power
is turned on or when
the PB/THUMBNAIL
mode is switched to the
CAMERA mode.
• Is the PB/THUMBNAIL lamp on? If the CAMERA lamp
is on, press the POWER/MODE switch so that the PB/
THUMBNAIL lamp turns on.
• Have you selected a clip that cannot be played back (clip
number is red)?
· Clips with a different SYSTEM MODE (1080i, 720P etc.)
cannot be played back.
· 24-bit audio clips (BITS PER SAMPLE is 24 in AUDIO of
CLIP PROPERTY) recorded with devices such as an AJ-
HPX3100 cannot be played back.
• Make sure the input selector on your television is set to
video input.
Read the television's instructions carefully and select the
correct video input connector for the camera-recorder.
• You may have turned down the camera-recorder's volume
control too far.
Adjust the volume level using the PAGE/AUDIO MON/VAR
button+.
• This unit does not support hot swap playback.
To replace one card with another during dubbing, stop the
dubbing first, and upon completing the replacement, resume
it.
• Cannot copy when clips are continuously linked in ONE
CLIP REC mode.
Select CAMERA mode and push the Operation lever in the
▼ direction (STOP) for 2 seconds to release the clip linking.
• Make sure the SD memory card is formatted correctly.
If it is not, format the card in the unit.
• The battery in the remote control may have run out.
If the remote control fails to work even if it is operated close
to the remote control sensor of the camera-recorder, it
means that the battery has run out. Replace it with new one.
• Make sure the remote control setting is the same for the
remote control unit and the camera-recorder.
If the REMOTE setting is different on the remote control and
the camera-recorder, the remote control will not work.
• There are some parts of the camera-recorder that make
a rattling sound in the PB/THUMBNAIL mode or when the
POWER/MODE switch is OFF. This is normal.
• This initialization operation is performed when the camera-
recorder starts up.
It occurs due to the construction of the camera-recorder and
is not indicative of any trouble.
(Page 74)
(Page 78)
(Page 100)
(Page 86)
(Page 16)
(Page 24 of Vol. 1)
(Page 24 of Vol. 1)
157