Writing Data On A Hard Disk Drive - Panasonic AGHPX255 Operating Instructions Manual

Writing data on a hard disk drive

1
Switch the mode to USB HOST.
• "Switching to the USB HOST mode" (Page 111)
• The thumbnail screen is displayed.
(USB HOST is displayed in the bottom right.)
2
Connect a hard disk drive via USB.
A hard disk drive that has not been formatted
with the camera-recorder must be formatted
as directed in "Formatting a hard disk drive"
(Page 114).
3
Insert a P2 card.
4
Press the MENU button and select HDD →
EXPORT from the thumbnail menu.
Specify the slot that contains the P2 card
bearing the data to be written to the hard disk
drive.
5
Select YES.
• This starts the write process.
• When the data is being written, a progress
bar is displayed. To discontinue writing, press
the SET button on the Operation lever, and
select YES when a confirmation message for
cancellation appears.
• When the writing is completed, the message
"COPY COMPLETED!" is displayed.
• To disable verification at the time of
writing, select HDD → SETUP from the
thumbnail menu and set the option
VERIFY to OFF. This speeds up writing
without verifying data writing.
• Select ALL SLOT to write data
collectively onto all P2 cards currently
inserted in the unit to the hard disk
drive.
• For a Type-S hard disk drive, data can be
written on a card basis. The data on up
to 23 P2 cards can be stored on the hard
disk drive. The data set on each P2 card is
recognized as a separate drive by the PC.
• If data on a P2 card that contains a
defective clip must be written to a hard
disk drive, then we recommend fixing or
deleting that clip before writing the data.
• When the process is discontinued during
verification, the data on the P2 card has
been written to the hard disk drive.
115