Functional Buttons - UNI-T UT10A Operating Manual

Model UT10A: OPERATING MANUAL

Functional Buttons

Below table indicated for information about the functional button operations
Button Operation Performed
Press SELECT to switch between resistance, capacitance, continuity buzzer and
SELECT
diode measurement modes; the Meter beeps. Resistance measurement is
default.
Press RELATIVE to enter and exit the REL mode in any measuring mode except
RELATIVE
in frequency/duty cycle; the Meter beeps.
l
Press HOLD once to enter hold mode.
DATA HOLD l
Press HOLD again to exit hold mode.
l
In Hold mode,
l
Press Hz/DUTY at DCV
measurement mode.
l
Press Hz/DUTY at ACV
Hz/DUTY
measurement mode.
l
The Meter will be at DCV: 400mV or ACV: 4V after stepping through frequency
and duty cycle measurement mode. Therefore it is necessary to turn the
rotary switch or turn off and on the Meter to resume to autoranging mode
when measuring higher voltage.
Functional Buttons
is displayed and the present value is shown.
to step through DCV, frequency and duty cycle
on the LCD will be disappeared.
to step through ACV, frequency and duty cycle
on the LCD will be disappeared.
11