Cutter Commands; Gs V M; Gs V M N - Citizen CT-S300 Command Reference Manual

2.2.10 Cutter Commands

GS V m ......... (1)

GS V m n ..... (2)

[Function] Cutting the paper
[Code] (1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
[Range] (1) m = 1, m = 49
(2) m = 66
[Outline] Performs the specified paper cutting.
[Caution] • In STANDARD MODE, this command only works when it is entered at the beginning
• Control to make the length of cut paper less than 10 mm is not excecuted.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n 0, the paper is fed by
• The basic calculation pitch is set by GS P.
m
0, 48 Full cut
1, 49 Partial cut (Leaving a bridge area uncut)
65 Paper feed by "cut position + {n
66 Paper feed by "cut position + {n
of a line.
"n basic calculation pitch" inches past the cut position, and then cut.
The paper feed amount is calculated with the vertical basic calculation pitch (y).
A fraction resulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
Function
basic calculation pitch}" and partial cut
basic calculation pitch}" and partial cut
— 65 —