3. Turn Power OFF
Press the "POWER / START" switch to turn off.
4. Subsequent Measurement
When a measurement is need again, 10 minutes, interval
is necessary between measurements.
5. Automatic Power OFF Function
If the unit is left without any operation after measure-
ment, an "Automatic Power-OFF Function" runs to turn
off the power after approximately 3 minutes. To continue
measurement, press the "POWER / START" switch again.
6. Battery Replacement
If the batteries are almost empty, the "
displayed. In this case, batteries should be replaced with
new one.
Remove the battery cover at mainframe and replace four
type "AA" batteries.
Note: The memory data are erased when you replace the
• The batteries that are included power the monitor. They
may not last as long as indicated.
• If manganese batteries are used at a low room tempera-
ture, such as in the winter or for other reasons, the bat-
" mark will be
teries may not function properly and you may not be able
to measure your blood pressure.
• Please dispose of used batteries properly to protect the
environmental.
- Eng 10 -
Battery cover
Batteries are almost empty.
Batteries are normal.
batteries.