Quick View - Sansui LCDWDVD320 Owner's Manual

TV operation
NOTE:
The unit is capable of holding a still
video image or On screen display image
on your television screen indefinitely. If
you leave the still video image or On
screen display image displayed on your
unit for an extended period of time, you
risk permanent damage to your televi-
sion screen.
16
CH
/
Press and release CH
channel automatically stops at the next
channel set into memory.
For proper operation, before selecting
channels, they should be set into the
memory. See pages 17 and 18
"Memorizing channels".
DISPLAY
Press DISPLAY to display the current information on the screen.
• Clock
• Channel number or VIDEO mode
selected
• Channel label (if preset)
• Stereo or SAP (second audio
program) audio status
• Content rating
• On timer, Sleep time (if preset)
• Picture size
Press DISPLAY again to clear the call display.

QUICK VIEW

This button allows you to go back to the
last channel selected by pressing
QUICK VIEW. Press QUICK VIEW
again to return to the last channel you
were watching.
MUTE
Press MUTE to switch off the sound.
The unit's sound will be silenced and
"MUTE" will briefly appear on the
screen. The sound can be switched
back on by pressing this button again
or the VOL + or –.
SLEEP
To set the unit to turn off after a preset
amount of time, press SLEEP on the
remote control. The clock will count up
10 minutes for each press of the
SLEEP button (0h00m, 0h10m, ...,
1h50m, 2h00m). After the sleep time is
programmed, the display will appear briefly every ten minutes to
remind you that the sleep timer is operating. To confirm the sleep
timer setting, press SLEEP and the remaining time will be displayed
for a few seconds. To cancel the sleep timer, press SLEEP repeat-
edly until the display turns to 0h00m.
(continued)
or . The
STEREO
SAP
TV-PG
ON TIMER
SLEEP TIMER 2h00m
FULL
CLOCK
A N T
A B C D
0 1 2
L V
8:30AM
ANT
ABCD
007
12:00AM CABLE
A N T
E F G H
0 0 7
MUTE
SLEEP
2h00m