Panasonic Viera U50A series Operating Instructions Manual page 17

Select the connection type
6
Connection Type
Please select network connection type.
WPS(Push button)
Search for access point
[WPS(Push button)]
1. Press the WPS button on the access point until the light flashes
2. Connect the Wireless LAN Adaptor and the access point
WPS(Push button)
1) Please press the 'WPS' button on the access
1) Please press the 'WPS' button on the access
point until its light flashes.
point until its light flashes.
2) When the light is flashing select 'Connect' on TV. 2) When the light is flashing select 'Connect' on
TV.
If you are unsure, please check the instruction If you are unsure, please check the instruction
manual of the access point. manual of the access point.
Connect
3. After the access point setting is finished, perform the connection test
Connection Test
4. Go to the next step
(Press twice)
[Search for access point]
Access points found automatically are listed.
1. Select your desired access point
Available Access Points
No. SSID
1 Access Point A
2 Access Point B
3 Access Point C
2. Access the encryption key input mode
Encryption Key Setting
Connection will be made with the following settings:-
SSID : Access Point A
Authentication type : WPA-PSK
Encryption type : TKIP
Please input the encryption key.
Encryption key
3. Enter the encryption key of the access point
Access Point Settings
Encryption key
A B C D E F G H I
U V W X Y Z 0 1
a b c d e f g h i
u v w x y z ( ) +
● Ensure that your access point supports WPS for this setup.
● WPS: Wi-Fi Protected Setup™
●
If the connection has failed, check the settings and positions of
your access point. And then, follow the on-screen instructions.
Check access point connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Wireless type Encrypt Reception
11n(2.4GHz)
11n(5GHz)
11n(5GHz)
●
If the selected access point is not encrypted, the confirmation
screen will be displayed. It is recommended to select the
encrypted access point.
Set characters
J K L M N O P Q R S T
2 3 4 5 6 7 8 9 ! : #
j k l m n o p q r s t
*
- . _
●
You can set characters by using numeric buttons.
select
● If your access point supports WPS (Push
button), then select this option. If not,
access
select [Search for access point].
: succeeded
The test is successful and the TV is connected to
the network.
: failed
Check the settings and connections. And then try
again.
select
access
: Encrypted access point
select
set
● To search access points
again
Y
● For the information of the
highlighted access point
INFO
Store
RETURN
(p. 78)
17