Panasonic Viera U50A series Operating Instructions Manual page 13

Connections
Mains lead and aerial
Mains lead
AC 220-240 V, 50 / 60 Hz
Mains lead
AC 220-240 V, 50 / 60 Hz
■
Mains lead
Push until both
side tabs click
■
Ferrite core
Installing the Ferrite core
Pull back the tabs
(in two places)
Note
●
Keep RF (antenna) cable away from the mains lead to avoid and minimise mains interference pickup.
● Do not place the RF cable under the TV.
To obtain optimum quality picture and sound, an aerial, the correct cable (75 Ω coaxial), and the correct terminating
●
plug are required.
●
If a communal aerial system is used, you may require the correct connection cable and plug between the wall aerial
socket and the TV.
● Your local Television Service Centre or dealer may be able to assist you in obtaining the correct aerial system for your
particular area and the accessories required.
●
Any matters regarding aerial installation, upgrading of existing systems or accessories required, and the costs
incurred, are the responsibility of you, the Customer.
See below "Mains lead"
Wind the cable Close
■
TV
Ferrite core - Large size
(supplied)
See below "Ferrite core"
Less than 10 cm
See below "Mains lead"
■
TV
RF cable
Make sure that To remove from the TV:
the mains lead is
securely fixed
If it is difficult to wind your cable, set
the cable through as shown.
●
Take care of the Ferrite core not to
move.
Aerial
RF cable
Aerial
Press both tabs
and pull on mains
tabs
connector to
release
13